ANALYTICAL MODEL OF CONVECTIVE-RELAXATION HEAT TRANSFER AND WELL PRODUCTIVITY DURING IN-SITU COMBUSTION

Authors

  • A. I. Bandura Ivano-Frankivsk National Technical University of Oil and Gas 76019, 15 Karpatska St., Ivano-Frankivsk, Ukraine
  • L. R Smolovyk Ivano-Frankivsk National Technical University of Oil and Gas 76019, 15 Karpatska St., Ivano-Frankivsk, Ukraine
  • D. O. Kopylov Ivano-Frankivsk National Technical University of Oil and Gas 76019, 15 Karpatska St., Ivano-Frankivsk, Ukraine

DOI:

https://doi.org/10.31471/1993-9868-2026-2(46)-252-262

Keywords:

high-viscosity oil; interphase heat transfer; two-temperature porous medium; third-order characteristic equation; formation heat loss; interphase thermal non-equilibrium

Abstract

The purpose of this paper is to construct an analytical solution to the two-temperature problem of convective-relaxation heat transfer during cyclic in-situ combustion of high-viscosity crude oil and to derive engineering-analytical relationships for estimating the flow rate increment of a production well. The formation of a temperature field in a homogeneous oil-saturated reservoir is examined under conditions of high Peclet numbers for the gas-liquid heat transfer agent, where its molecular thermal conductivity is negligible compared to the longitudinal thermal conductivity of the solid rock matrix. The mathematical model accounts for local thermal disequilibrium between the moving fluid and the solid skeleton, as well as linear heat losses to the impermeable overburden and
underburden of the productive layer according to the Newton-Lauwerier scheme. By transforming into a moving
coordinate system attached to the combustion front and approximating the narrow coke oxidation zone as a point
heat source, the initial fourth-order system of partial differential equations is reduced to a single third-order
ordinary differential equation with derivative matching conditions at the front. In the adiabatic approximation, the
characteristic equation factors into a zero root and a quadratic trinomial with a strictly positive discriminant, yielding closed-form elementary expressions for the phase temperature distributions, the interphase temperature head
wave, and the coordinate of its maximum ahead of the combustion front. Using the perturbation method, it is
demonstrated that accounting for lateral heat losses shifts the zero characteristic root into the domain of small
positive values. This physically explains the reduction of the peak front temperature from an adiabatic value of
1530 °C to realistic reservoir values of 698.5–1158.6 °C, the formation of a dome-shaped temperature maximum,
and thermal recuperation in the burned-out zone, where the rock matrix cools significantly slower than the gas
stream. Based on the method of total filtration resistances, it is established that advancing the combustion front by
20–35 m, together with a convective heating aureole of 6.75–8.19 m in width, increases the well flow rate by a
factor of 4.5–7.5 due to oil viscosity reduction.

Downloads

Download data is not yet available.

References

1. Smolovyk, L. R. (2025). Modeliuvannia teplovoho vplyvu na poklady z vysokoviazkymy naftamy [Modeling of thermal impact on heavy oil reservoirs]. Prykarpatskyi Visnyk NTSh. Chyslo, (21(79)), 147–153. https://doi.org/10.31471/2304-7399-2025-21(79)-147-153 (in Ukrainian)

2. Sun, J., Wang, B., Shu, Y., Wang, Y., Pan, Y., & Tian, C. (2025). The numerical simulation study on the heat transfer mechanism in heavy oil reservoirs during in-situ combustion. Processes, 13(1), Article 56. https://doi.org/10.3390/pr13010056

3. Antolinez, J. D., Miri, R., & Nouri, A. (2023). In situ combustion: A comprehensive review of the

current state of knowledge. Energies, 16(17), Article 6306. https://doi.org/10.3390/en16176306

4. Nield, D. A., & Bejan, A. (2017). Convection in porous media (5th ed.). Springer. https://doi.org/10.1007/978-3-319-49562-0

5. Tao, L., Hu, Z., Xu, Z., Zhang, X., Ding, Y., Wang, C., Chen, D., & Li, S. (2024). Experimental investigation of in situ combustion (ISC) in heavy oil thermal recovery. Geoenergy Science and Engineering, 233, Article 212488. https://doi.org/10.1016/j.geoen.2023.212488

6. Yang, M., Chai, M., Yuan, S., Feng, T., Wang, S., Zhang, J., Feng, Q., Chen, Z., Wei, T., Wu, G., & Yu, J. (2024). In-situ combustion for heavy oil and oil sands recovery: Recent progress, field applications, and future perspectives. Energy & Fuels, 38(12), 10395–10420. https://doi.org/10.1021/acs.energyfuels.3c05067

Published

20.11.2026

How to Cite

Bandura, A. I., Smolovyk, L. R., & Kopylov, D. O. (2026). ANALYTICAL MODEL OF CONVECTIVE-RELAXATION HEAT TRANSFER AND WELL PRODUCTIVITY DURING IN-SITU COMBUSTION. Oil and Gas Power Engineering, (2(46), 252–262. https://doi.org/10.31471/1993-9868-2026-2(46)-252-262

Issue

Section

SCIENCE AND MODERN TECHNOLOGIES

Similar Articles

<< < 32 33 34 35 36 37 38 39 40 41 > >> 

You may also start an advanced similarity search for this article.